what grit sandpaper to sand clear coat

Best answer 600 grit People also ask What grit of sand do you use to sand clear coat? The only objective of the first grit used to sand clear coat is to get it completely flat, and nothing else. 600 grit is aggressive enough to sand it flat witho

Best answer


600 grit

People also ask


  • What grit of sand do you use to sand clear coat?

  • The only objective of the first grit used to sand clear coat is to get it completely flat, and nothing else. 600 grit is aggressive enough to sand it flat without doing any damage to the clear coat. Remember, it is plastic, so too coarse of sandpaper can get very difficult to remove scratches from.

  • What grit sandpaper should I use for woodworking?

  • For optimal results, start with the 600-grit sandpaper, and then sand later with the higher-grit paper, such as a 1500-2000-grit paper. Otherwise, go straight to the higher-grit paper.

  • What is the goal of wet sanding clear coat with 600 grits?

  • What is the goal of using 600 grit to start wet sanding clear coat? And why 600 and not other grits, like 800 or 1,000? The only objective of the first grit used to sand clear coat is to get it completely flat, and nothing else. 600 grit is aggressive enough to sand it flat without doing any damage to the clear coat.

  • How do you get sandpaper off of clear coat?

  • Soak all of your sandpaper. Soak for at least 60 minutes in clean water to prevent sharp edges from scratching the clear coat. Soak a rag. Next soak a rag in water with a little bit of soap. Use about a cap of soap per gallon of water, or as directed by your soap label. Focus on sanding one small section at a time.

    Leave a Reply