do you have to sand between coats of polyurethane

Best answer Some manufacturers of water-based polyurethanesdo not require sanding between coats, as long as you observe specific recoating times. Most manufacturers of oil-based polyurethanes do require sanding between coats. However, aside from the

Best answer


Some manufacturers of water-based polyurethanesdo not require sanding between coats, as long as you observe specific recoating times. Most manufacturers of oil-based polyurethanes do require sanding between coats. However, aside from the technical aspects, you should consider sanding between coats for aesthetic reasons.

People also ask


  • Do you need to sand after applying polyurethane?

  • When not done correctly, you will need to sand and recoat the entire surface. If you must sand the final coat, the wet sanding method is safer and gives a smoother or glass-like finish on the wood. The best solution is to ensure you get the polyurethane application right the first time, so you don鈥檛 have to go through this trouble.

  • How many coats of polyurethane do I need to sand wood?

  • Before you start either of these, make sure there are enough coats of polyurethane on the surface. If you have only one coat, any type of sanding method will get to the bare wood, and you鈥檒l have to apply another coat. How Many Coats of Polyurethane?

  • What happens if you put more than 3 coats of polyurethane?

  • Additional layers of polyurethane would mean that you sand each layer, which can be time-consuming mainly when you apply more than 3 coats, and you are forced to wait so that they all dry. Another bad thing about applying many coats is that poly tends to get thick and gloppy and, hence, would likely peel without long.

  • Should Minwax polyurethane be sanded between coats?

  • Minwax Polyurethane should be sanded between coats. Sand with 320 grit sandpaper to get rid of any fine particles of dust that have settled on it while it was still wet. Sanding in this case not only allows for a smoother finish but can also help abrade the surface and increase inter-coat adhesion.

    Leave a Reply